�鶹��

Self-Programmable Remote Car Key Replacement (Up To 2010*)

An inexpensive replacement for your original remote key fob, the Keyless2Go car key replacement is self-programmable for vehicles up to 2010* and comes with easy do-it-yourself instructions to help you program your new car key at home. Enjoy keyless entry on a wide variety of vehicles from Buick, Chevrolet and GMC. Each fob key has been pre-tested to ensure compatibility and that signals are transmitting properly. Every remote key fob comes complete with batteries and free tech support to help get your new smart key working.

*2011 - up Vehicles must be programmed by a locksmith or dealership.

Compatibility:

BUICK ENCLAVE 2008 - 2014
CADILLAC ESCALADE 2007 - 2009
CHEVROLET AVALANCHE 2007 - 2013
CHEVROLET CAPTIVA SPORT 2012 - 2014
CHEVROLET EQUINOX 2007 - 2014
CHEVROLET EXPRESS 2011 - 2014
CHEVROLET SILVERADO 2007 - 2013 (excludes 2007 Classic model)��
CHEVROLET SUBURBAN 1500 2007 - 2013
CHEVROLET SUBURBAN 2500 2007 - 2013
CHEVROLET TAHOE 2007 - 2014
CHEVROLET TRAVERSE 2009 - 2014
GMC ACADIA 2007 - 2014
GMC SIERRA 1500 2007 - 2014
GMC SIERRA 1500 HD 2007��
GMC SIERRA 2500 HD 2007 - 2014
GMC SIERRA 3500 2007��
GMC SIERRA 3500 HD 2007 - 2014
GMC YUKON 2007 - 2014
GMC YUKON XL 1500 2007 - 2014
GMC YUKON XL 2500 2007 - 2013
PONTIAC TORRENT 2007 - 2009
SATURN OUTLOOK 2007 - 2009

How to Program your Keyless2Go Key Fob Replacement:

Option 1 (for vehicles with the Driver Information Center)

1.Insert key and switch the ignition ON (just shy of starting vehicle without cranking engine)
2. Press vehicle information button until PRESS TO RELEARN REMOTE KEY is displayed.
3. Press the set/reset button (button will have a checkmark) until REMOTE KEY LEARNING ACTIVE is displayed. Vehicle is nowin programming mode.
4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal willbe heard indicating successful programming.
5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALLremotes including existing remotes.
6. To exit programming mode turn ignition OFF, remove key and test all remotes.

Option 2 (for vehicles without the Driver Information Center)

1. Insert key into the ignition and turn to ON (Just shy of starting vehicle without cranking engine).
2. Press the trip odometer reset button until RELEARN REMOTE KEY is displayed.
3. Press and hold the trip odometer reset button for approximately 3 seconds until REMOTE KEY LEARNING ACTIVE displays.
4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal willbe heard indicating successful programming.
5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALLremotes including existing remotes.
6. To exit programming mode turn ignition OFF, remove key and test all remotes.